Nimesulide
Quantitative Analysis On UV Visible Spectrophotometer
Active Raw Material, Tablets, Enteric Coated Pellets and
Injection
¨ By
Applying the below method of testing of Nimesulide you can Analyze active raw
material, tablets, enteric coated pellets and injection dosage form.
¨ Absorbance
will be measured at 392 nm using
UV-Visible Spectrophotometer.
¨ Solvent
used 0.1M NaOH
¨ Standard
Preparation: Accurately weight Nimesulide working standard 50mg using
butter paper and transfer it to a 50ml volumetric flask.
¨ Add
20ml of 0.1M NaOH and sonicate for 10 minutes. Then make up the volume with
0.1M NaOH up to 100ml.
¨ Further
take 1 ml of this solution into 100ml volumetric flask and make up the volume
up to 100ml with 0.1 M NaOH.
¨ Sample
Preparation: Accurately weight sample equivalent to 50 mg of Nimesulide
using butter paper and transfer it to a 50ml volumetric flask.
¨ Add
20ml of 0.1M NaOH, first sonicate for 10 minutes and then stir for further 10
minutes. Make up the volume with 0.1M NaOH up to 100ml.
¨ Filter
the sample through whatman filter paper.
¨ Further
take 1 ml of this solution into 100ml volumetric flask and make up the volume up
to 50ml with 0.1 M NaOH.
¨ In
case of granules, pellets and tablets it is necessary to crush the sample and
make fine powder sample foe better solubility.
¨ Measure
the absorbance of both sample and standard solutions in a 1 cm quartz cell on a
U.V/ Visible spectrophotometer at 392 nm.
¨ Calculation:
¨ %age
= Abs. of sample x conc. of stand x
100
¨ Abs. Standard x conc. of sample
0 Comments